SMR Gearbox Installation
Satisfactory functionality depends on suitable set up. lubrication and maintenance. consequently it is vital that the directions during the installation and servicing leaflet. supplied with every single gearbox. are followed carefully. several of the essential facets of belt and torque-arm installation are listed below.
1. Install pulley on gearbox input shaft as near towards the reducer attainable, and mount reducer on driven shaft as shut to bearing as practical. failure to complete this may result in extra loads during the input shaft bearings and output bearings and could result in their premature failure.
2. Install motor and wedge belt drive with the belt pull at approximately 90° for the center line involving driven and input shafts. this can permit tensioning of the wedge belt drive with the torque arm which should preferably be in stress. if output hub runs anti-clockwise. torque arm need to be positioned the right.
3. lnstall torque-arm fulcrum on the rigid help so that the torque-arm will be at approximately ideal angles towards the center line with the driven shaft along with the torque arm situation bolt. make sure there may be adequate take up during the turnbuckle for belt tension adjustment.
Preserve close.
Bell drive may be found in any effortless postion. in the event the torque arm is usually to be applied to tighten the belts, the drive ought to be at about tight angle on the line in between the input and output shafts.
Bell drive can be located towards the right if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that shown from the illustration.
Torque arm and belt consider up.
Torque arm could possibly be mounted on the appropriate if sought after.