Electrical power UNITS FOR LIFT TABLE one
Basic Description
This power unit is built solely for that small lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit has become widely employed from the market of logistic units including minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed through the solenoid valve with all the velocity managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is made solely for that medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve along with the speed controlled through the adjustable needle valve. When the lift rises to a large positoin, but the power provide is cut, the lowering movement is controlled through the guide override perform.
Energy UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is designed exclusively for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as pace managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is designed solely to the large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is lower, the reducing movement is managed through the manual override perform.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned ahead of set up of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which must also be clean and free of charge of impurities.N46 hydraulic oil is proposed.
4. Oil changing is needed just after the original 100 operation hours,afterwards as soon as each 3000 hrs.
5. The electrical power unit proven is made to be mounted vertically.